Please note: Manufacturing tolerances may affect the dimensions shown above, so please check these measurements against your MAXTRAX Recovery Tracks before drilling. Measure twice. Cut once.
MKII
EXTREME
LITE
MINI
Each MAXTRAX Mounting Pin Set includes 4 Nylon and stainless-steel quick-release Mounting Pins (which can securely hold 2 or 4 MAXTRAX Recovery Tracks), 4 stainless-steel Nyloc nuts and 4 flat stainless-steel washers. You’ll notice that there's a hole in the top of each mounting pin to allow for a padlock.
All 4 Mounting Pins MUST be used for securing your MAXTRAX Recovery Tracks.
When installing the Mounting Pins ensure that the knuckles are aligned so that they’re in the same orientation as the keyholes in the MAXTRAX Recovery Tracks.
The padlock hole through the shaft should not be visible when you are installing the Mounting Pins. It should only appear once the knuckle has been turned 90º to lock down your MAXTRAX.
Apply lubricant to the stainless-steel threads prior to tightening the nuts and tighten using hand tools only; DO NOT tighten with power tools as this can generate sufficient heat to cause the Nyloc nut to bind to the thread prematurely.
Once the Mounting Pins are installed it’s easy to mount your MAXTRAX Recovery Tracks.
We strongly recommend fitting padlocks through a couple of the most easily accessible Mounting Pin/s to reduce the risk of theft of your MAXTRAX Recovery Tracks, and also to prevent the knuckle/s from unintentionally rotating whilst driving.
We also strongly recommend that before driving, and regularly during your journey, particularly on rough roads and tracks, you should check that the Mounting Pins and the MAXTRAX Recovery Tracks are secure.
The knuckles can sometimes become difficult to turn if they haven’t been used for a while as the assembly may gradually become filled with road dust and grime. Rinsing with water or spraying with a water-dispersant compound may help.
We also make a handy Xtract Tool for those with delicate fingers.